From grout surface treatment to full wall cavity remediation — the right scope for your specific bathroom mold situation in Lurgan, PA.
🔍
Bathroom Mold Investigation & Source Identification
Systematic investigation: moisture readings at shower walls, floor at pan perimeter, toilet base, under sink. Borescope through wall cavities. Exhaust fan flow measurement. Written findings before any demolition.
🚿
Shower & Tub Surround Mold Remediation
Mold in shower and tub surrounds is most commonly found in one of three locations: surface grout and caulk (visible, usually Aspergillus or Cladosporium); behind tile on the CBU or drywall backer (typically from grout failure allowing water infiltration); or in the wall cavity behind the shower from a failed pan liner or cracked pan. Each requires a different approach — our Lurgan specialists assess which applies before proposing removal scope.
💧
Subfloor Mold Removal — Toilet Leaks & Shower Pan Failure
A slow toilet wax ring leak or cracked shower pan can saturate subfloor material for months before any visible symptoms appear above the surface. By the time vinyl or tile shows staining or soft spots, the subfloor below often has significant mold growth. Our Lurgan, PA team removes contaminated subfloor sections, treats remaining structural material, and specifies the appropriate replacement — SBC, CPP, or cement backer depending on application.
🔢
Exhaust Fan Assessment & Upgrade Recommendation
We measure your bathroom fan's actual CFM output and compare it to the square footage requirement. An undersized or blocked exhaust fan is often the cause of ceiling and wall mold in Lurgan bathrooms — a fan upgrade is the lowest-cost, highest-impact prevention step.
🌟
Ceiling Mold — Condensation & Leak Sources
Bathroom ceiling mold occurs in two distinct scenarios: condensation from chronic inadequate ventilation (which leaves a diffuse, widespread pattern on the ceiling surface), and drip from a bathroom above (which creates a concentrated pattern tracing the path of the drip). Our Lurgan, PA team distinguishes between these, addresses the correct source, and remediates accordingly — surface treatment for condensation mold, cavity investigation and source repair for drip sources.
📄
Post-Remediation Clearance & Documentation
After Bathroom Mold Removal in your Lurgan, PA bathroom, we arrange post-removal air sampling by an independent IH — confirming spore counts are back to acceptable levels before tile and drywall reinstallation. Written clearance report suitable for insurance use.
